Note: Follow the disassembly procedure in the numerical order given.
2-2.
PANEL (L/R) ASSY
Note 2: When installing the panel (L/R) assy,
check the presence or absence of a mark,
do not mistake the right and left.
Mark on the panel (R) assy
3 panel (R) assy
2 two claws
2-3.
PANEL (REAR L) BLOCK, PANEL (REAR R)
5 seven screws
(step) (BVTP3)
7 two screws
(step) (BVTP3)
8 panel (rear R)
2 claw
1 two bosses
3 foot (corner)
Note 2: When installing the panel,
check that J251 installed the
position shown in the figure.
J251
– Rear view –
1 two screws
(BVTP3
10)
– Rear bottom view –
Note 1: Please spread a sheet under
a unit not to injure front side.
ower or
power cord
– Rear view –
3 panel (L) assy
Note 1: Please spread a sheet under
a unit not to injure front side.
etti
2 claw
1 two bosses
3 foot (corner)
HT-ST7
1 two screws
(BVTP3
10)
2 two claws
5 seven screws
(step) (BVTP3)
6 panel (rear L) block
4 Remove the power cord
from the hook of panel
(rear L).
– Rear bottom view –
7