Installing An Additional Microprocessor - IBM X3610 Installation Manual

v The ID that is assigned to each bay is printed on the front of the server.
The following illustration shows how to install a hard disk drive.
Hard disk
drive filler
To install a drive in a hard disk drive bay, complete the following steps.
Attention:
than 10 minutes without either a drive or a filler panel installed in each bay.
1. Read the safety information that begins on page v, and "Installation guidelines"
2. Remove the filler panel from one of the empty hard disk drive bays.
3. Install the hard disk drive in the hard disk drive bay:
If you have other optional devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 24.

Installing an additional microprocessor

The following notes describe the type of microprocessor that the server supports
and other information that you must consider when installing a microprocessor:
v The server supports certain Intel
16
IBM System x3610 Type 7942: Installation Guide
To maintain proper system cooling, do not operate the server for more
on page 9.
a. Make sure that the tray handle is open (that is, perpendicular to the drive).
b. Align the drive assembly with the guide rails in the bay.
c. Gently push the drive assembly into the bay until the drive stops.
d. Push the tray handle to the closed (locked) position.
e. Check the hard disk drive status LED to verify that the hard disk drive is
operating correctly.
If the amber hard disk drive status LED for a drive is lit continuously, that
drive is faulty and must be replaced. If the green hard disk drive activity LED
is flashing, the drive is being accessed.
Note: You might have to reconfigure the disk arrays after you install hard disk
drives. See "Using the RAID configuration programs" on page 32.
grid array 771 (FC-LGA 771) microprocessors, which are designed for the
LGA771 socket. See http://www.ibm.com/servers/eserver/serverproven/compat/
us/ for a list of supported microprocessors.
Important: Dual-core and quad-core microprocessors are not interchangeable
and cannot be used in the same server. For example, if the server has a
dual-core microprocessor, you cannot install a quad-core microprocessor as the
Hard disk drive
® ®
Xeon dual-core or quad-core flip-chip land