Reproducing The Time Code/User Bit - Panasonic DVCPRO50 AJ-D960EG Operating Instructions Manual

Reproducing the time code/user bit

1
2
3
4
<Notes>
• The colon between the seconds and frames changes to a period when the drop frame time
code is read. (In the 525 mode only.)
• When the time code signal cannot be read, the time code is automatically interpolated by
the CTL signal.
The display appears as shown below.
Place the unit in the stop mode.
Set the TC/CTL switch to TC.
Set the TC/UB switch to TC or UB.
TC: The time code is displayed.
UB: The user bit is displayed.
• When it is no longer possible to read the time code, it is interpolated using the
CTL signal.
Press the PLAY button.
Playback now commences, and the time code appears on the display.
When setup menu No. 007 (SUPER) is ON, the time code value is superimposed onto
the video signal from the VIDEO OUT 3/SERIAL OUT 3 connector.
T R 00:01:04:07
The colon between the seconds and frames
changes to a period during drop frame mode.
(In the 525 mode only.)
When the time code signal cannot be read,
an asterix ( ) is displayed.
" ": 1, 3 field
" ": 2, 4 field
92 (E)