Panasonic DVCPRO50 AJ-D960EG Operating Instructions Manual page 72

Setup menus
USER menu
<EDIT>
No.
317
318
320
321
The underline on the setting item denotes the initial setting.
(continued)
Item Setting
Superimposed Superimposed
No.
display display
AUD MEM 0000
MODE 0001
0002 AMU_VO
0003
0004 INT_VO
AUD MEM 0000
CH 0001
0002
0003
VAR FWD 0000
MAX 0001
0002
VAR REV 0000
MAX 0001
0002
72 (E)
OFF Establishes the setting for voice-over and/or audio cross
channel editing using the AJ-YA752 audio memory unit or
AMU_X
built-in audio memory.
0: Neither voice-over nor audio cross channel editing is
INT_X
performed.
1: Audio cross channel editing is performed using the AJ-
YA752 audio memory unit.
2: Voice-over editing is performed using the AJ-YA752 audio
memory unit.
3: Audio cross channel editing is performed using the internal
audio memory.
4: Voice-over editing is performed using the internal audio
memory.
<Notes>
• The RS-232C interface will not function with the 1 (AMU_X)
or 2 (AMU_VO) setting.
• When the 2 (AMU_VO) or 4 (INT_VO) setting is selected,
the channels selected by the setup menu item No. 318 (AUD
MEM CH) setting are output to the monitor with any delay
automatically eliminated internally using the CUE system.
Consequently, CUE audio no longer functions, and the setup
menu item No. 726 (REC CUE) also loses its function since
this is now automatically switched internally.
Up to 20 seconds of sound can be stored in the unit's
internal memory. It should be borne in mind that even if an
attempt is made to store more than 20 seconds of sound in
the memory, all the audio signals in excess of the memory's
20-second capacity will fail to be stored.
• Refer to the instruction manual of the AJ-YA752 audio
memory unit for details on how to use each mode using this
unit.
CH1 This sets the channel for the voice-over or audio cross
channel editing which is performed using the AJ-YA752 audio
CH2
memory unit or internal audio memory.
CH3
0: The signals are recorded onto CH1.
CH4
1: The signals are recorded onto CH2.
2: The signals are recorded onto CH3.
3: The signals are recorded onto CH4.
<Note>
This setting has no effect when AMU_VO has been selected
as the setup menu No. 317 (AUD MEM MODE) setting.
This sets the maximum VAR FWD speed.
+4.1
0: +4.1 (+3.1) speed
+2
1: +2 (+1.85) speed
+1
2: +1 speed
<Notes>
• The value for the DV/DVCAM format is shown in parenthesis
( ).
• At any speed setting other than 0 (+4.1 ), the phase cannot
be synchronized from the editing controller.
–4.1
This sets the maximum VAR REV speed.
0: –4.1 (–3.1) speed
–2
1: –2 (–1.85) speed
–1
2: –1 speed
<Note>
The value for the DV/DVCAM format is shown in parenthesis
( ).
Description