Panasonic DVCPRO50 AJ-D960EG Operating Instructions Manual page 45

Voice-over facility
For operation with an editing controller (AG-A850)
1
2
3
4
5
6
7
8
9
10
<Note>
For further details on the AG-A850, refer to the operating instructions of the AG-A850.
(internal)
MIC
AMP
Microphone
TV monitor
Ref.
Select INT_VO as the setup menu No. 317 (AUD MEM MODE) setting.
Select the same setting for the channel (any channel from CH1 to CH4) on which the
sound is to be recorded and for the setup menu No. 318 (AUD MEM CH) channel.
Insert the cassette tape for which the voice-over editing is to be performed into the
VTR.
Set the CONTROL switch on the VTR to the REMOTE position.
Set the controller's SOURCE selector to AUX1.
Press the insert button for the channel (channel selected in step 2) on which the sound
is to be recorded.
Enter the IN and OUT points of the positions where voice-over editing is to be
performed.
Press the PREVIEW button.
While watching the TV monitor, input the audio signals to be recorded between the IN
point and OUT point into the channel that was selected in step 6. The audio signals to
be recorded are stored in memory.
Press the AUTO EDIT button to proceed with editing. The audio signals stored in the
memory are recorded from the memory onto the cassette tape.
45 (E)
* Connect to the channel (any channel
from CH1 to CH4) on which the sound
is to be recorded.
ANALOGUE
AUDIO IN*
VIDEO
OUT
REMOTE
IN/OUT
RECORDER
CONTROLLER
AJ-D960
AG-A850