Test Mode - Pioneer XC-Z9 Service Manual

1

8.1.4 TEST MODE

QQ
3 7 63 1515 0
A
POWER ON
POWER
ON
B
DISC SET
<TRAY OPEN>
OPEN/CLOSE
(Player)
OPEN/CLOSE
C
TE
L 13942296513
TEST MODE: PLAY
<PLAY>
Press the play key
( ) of the normal
remote control unit.
D
Notes:
• The audio signal are outputted during the test mode.
• The SKIP key and the SCAN key are effective during the test mode.
E
TEST MODE: OFF
ESC
www
GGF1381
Test mode
remote control
unit
F
50
1
http://www.xiaoyu163.com
2
DVD disc
ESC
GGF1381
Test mode
remote control
unit
POWER
x ao
y
. i
2
http://www.xiaoyu163.com
3
8
How to display the error rate
Turn the power on in Service Test Mode.
Short circuit the STEST TEST land on the MAIN ASSY
and then turn on the AC power.
(See "6.1 SERVICE TEST MODE")
∗DISC Adjustment Mode
Limited only to Service Test Mode, it is used for adjusting the
servo for playing back DVDs.
Only the service test DVD (GGV1025) is supported.
Operations using other DVDs are not guaranteed.
The DVD supports only basic playback, measurement of the
error rate, track selection, and SCAN.
Other operations are not guaranteed.
<TRAY CLOSE>
OPEN/CLOSE
(Player)
OPEN/CLOSE
Q Q
3 6 7 1 3
An error rate is displayed
5
9 9 0 E – 6
The error rate is displayed as above.
But this means " 9.90E – 6 ".
Note: Even if you intend to continue using the unit
after using Service Test Mode, be sure to
turn the power off and then back on.
u163
ON
.
XC-Z9
3
4
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
m
co
4
9 9
2 8 9 9