Industrial Ethernet - Siemens S7-300 Configuration Manual

11.3.5

Industrial Ethernet

The "Industrial Ethernet" entry in the navigation panel provides information on the Ethernet
interfaces.
Interface setting
If the device has several interfaces, the interface number (for example "Interface X1") is
displayed in a drop-down list in the title bar.
Select the required interface from the drop-down list. The setting applies to the "Parameters"
and "Statistics" tabs of the "Industrial Ethernet" entry in the navigation panel.
"Parameter" tab
This page shows you the various parameters of the MAC address, the IP address and the
LAN attachments.
Parameters
Network attachment
MAC address
(active)
MAC address (set in
the factory)
Device name
IP parameters
IP address
Subnet mask
Default router
Router used
IP settings
Physical properties
Port number
Link status
Setting
Configuring and commissioning S7 CPs for Industrial Ethernet
Configuration Manual, 09/2013, C79000-G8976-C182-13
Function
Active MAC address of the CP
MAC address set in the factory
PROFINET device name configured in STEP 7 (X1 or X2 interface)
IP address of the CP (or of the interface)
Configured subnet mask
IP address of a configured router
IP address of the router used
How the IP address is assigned (for example, STEP 7, DHCP ...)
Port number of the LAN interface
Status of the LAN port:
OK
•
no link
•
disabled
•
Display of the individual network settings configured in STEP 7:
Configured
•
automatic (automatic setting / autonegotiation)
•
Web diagnostics
11.3 Diagnostics pages of the CP
179