Vivitar DVR 920HDV2 User Manual page 6

When powering the digital video recorder ON for the first time the digital video recorder will
take you through the initial setup.
Powering the Digital video recorder ON
1) Batteries
Make sure the batteries have been inserted
properly into your digital video recorder, according
to the polarity shown inside the battery
compartment.
Use 4 x AAA (1.5v) batteries. Alkaline batteries
are recommended. (Batteries not included.)
Note:

Remove the batteries from the camera when not in use for an extended period.

Do not mix alkaline and non-alkaline batteries.

Some camera features (Flash) will not work if the battery power level is low.

When the battery power is low the battery icon turns red and the camera will
automatically turn off a few seconds later.

The energy status of the power is displayed on LCD as shown below:
Full battery power
2) SD Card
Make sure an SDHC card has been properly inserted
into your camera. (SDHC card not included.)
To properly insert the SD Card:
- Push the SD card into the slot in the direction shown on
the digital video recorder (see SD icon by the SD card
slot).
- Push the SD card until you hear a slight clicking sound.
This indicates the SD card has been inserted correctly.
- If you captured images with the internal memory, a „Move to Card" message will appear
Medium battery power
5
Low battery power