Length Measurement; Area Measurement - Bosch GLM 50 C Operating/Safety Instructions Manual

Length Measurement

For length measurement, press the function button 7
[Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indicator
for length measurement
appears in the status bar. Select length measurement
by pressing the measure button 2 [ ]. Activate the
laser by pressing the measure button 2 [ ]. The laser
will be switched on. Aim the laser at the object you
want to measure the distance to. Press the measure
button 2 [ ] again to take the measurement. The mea-
surement will be shown in the result line e.
Press the measure button 2 [ ] and
the previous measurement will move
to the bottom line of the measured-
4'02" 27⁄32
value lines d.
0.0° 8'05" 1 6
Press the measure button 2 [ ] for a
12'07" 17⁄32
new measurement which will display
on the result line e.
16'11" ⅜
Press the measure button 2 [ ] and
the measurement from the bottom line
of the measured-value lines d will move to the middle
line of the measured-value lines d and the measure-
ment from the result line e will move to the bottom line
of the measured-value lines d.
Press the measure button 2 [ ] for a new measure-
ment which will display on the result line e.
As you continue to take measurements, this cycle will
continue. The unit can display up to 3 previous mea-
surements.
The last three measurements will display on the mea-
sured-value lines d and the current measurement will
display on the result line e.

Area Measurement

For area measurements, press the function button 7
[Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indica-
-24-
and the word "Length"