Other Speaker Setup Options; Wireless System Connection - Panasonic SC-HT65 Operating Instructions Manual

Other speaker setup options

Fitting optional speaker stands
■
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance between screws as shown in the diagram.
• The stands must be able to support over 10 kg.
• The stands must be stable even if the speakers
are in a high position.
Attaching to a wall
■
You can attach the surround, center and front speakers to a wall.
1
Drive the screw (not included) into the wall
Ø4.0 mm
Wall or pillar
Note
The wall or pillar on which the speakers are to be
attached should be capable of supporting 10 kg per
screw. Consult a qualified building contractor when
attaching the speakers to a wall. Improper attachment
may result in damage to the wall and speakers.
Reattach the speaker cable
■
Leave about
80 mm

Wireless system connection

Set your sound free with Panasonic's wireless
receiver and speaker systems
Attach the SH-FX65 digital transceiver for wireless surround sound.
You can also connect your portable audio equipment to the wireless
system.
For details, refer to the operating instructions for SH-FX65.
Note
Remove the digital transmitter cover before installing any optional
Panasonic wireless accessory.
• Replace the cover when the digital transmitter is not in use.
SC-HT65 GN-En.indb 7
(not included)
For attaching to speaker stands
At least 30 mm
Ø7.0 to 9.4 mm
4.0 to 6.0 mm
Pull out the
2
cable through
the hole.
Metal screw holes
5 mm, pitch 0.8 mm
2
Fit the speaker securely onto the screw(s) with the hole(s).
Front speakers
Attach to a wall without the base
and stand.
384 mm
Insert the
1
cable from
bottom.
Push!
You can use the blunt end of a writing instrument
to push here until the cover pops out.
Plate thickness plus
7 mm to 10 mm
Speaker stand
(not included)
Center speaker
190 mm
Surround speaker
Digital transmitter cover
PUSH PUSH
DIGITAL
PUSH PUSH
TRANSMITTER
Push!
8/17/2007 4:20:01 PM
7