Konica Minolta bizhub 4050 User Manual page 50

4.7 Major messages and actions
Message
[Memory Overflow]
[Replace Staples]
[Stored Job Error]
[HDD Capacity Over]
[Document Registration
Overload]
[Memory Full (FAX)]
[Job Registration Limit Over]
[Connection Failed]
[Writing Error]
[Matching paper size not
available.]
[Out of the Range of Auto
Zoom]
[Place Original on Glass]
[Place Original on ADF]
[Duplex Copy Disabled]
[Scan TX Failed]
[Off-Hook]
[Fax TX Failed]
[Fax RX Failed]
[I-Fax TX Failed]
[I-Fax RX Failed]
[E-mail forwarding failed.]
[PC-FAX Restricted]
[Maintenance/Troubleshooting]
Description
Data has been received over the
maximum memory size.
All the available space in memo-
ry has been used up by docu-
ment scanning.
Staples have run out.
The option configuration is dif-
ferent from that specified when a
job was saved.
The HDD capacity has become
full.
The number of files on the HDD
has reached the upper limit.
The fax data storage area has
become full.
The number of registered jobs
has reached the upper limit.
Failed to connect to the FTP
server.
An error has occurred while sav-
ing data onto a USB memory de-
vice.
Paper appropriate for a print job
is not loaded in the tray.
The auto zoom ratio setting ex-
ceeds the allowable range.
The original of an invalid size is
loaded on the ADF.
No original is loaded on the ADF.
The size of the loaded paper is
not available for 2-sided copy.
Scan transmission has failed.
The handset remains picked up
after a manual transmission.
Fax transmission has failed.
Fax receiving has failed.
An error occurred while sending
an Internet fax, and the job was
not ended normally.
An error occurred while receiving
an Internet fax, and the job was
not ended normally.
An error occurred while forward-
ing the received fax by E-mail,
and the job was ended normally.
PC-Fax TX is prohibited.
Remedy
Cancel the job to reduce the amount
of data, then execute the job again.
Reduce the amount of original data.
Replace the staple case.
For details, refer to page 2-7.
Return to the option configuration
specified when a job was saved.
Delete data saved on the HDD, if
necessary.
Delete data saved on the HDD, if
necessary.
When sending fax data, send only
the scanned original, or manually
send it again.
When receiving fax data, print or de-
lete data saved in memory.
Wait until a job has been completed,
or delete a current job.
Check that the destination has been
registered correctly.
Cancel the job, then check that the
USB memory is in the write enable
state.
Load the appropriate paper in the
tray, then specify the correct size
and type for the loaded paper on the
Control Panel.
Specify the zoom ratio between 25
and 400%.
Scan the original from the Original
Glass.
Load the original on the ADF.
Scan the original of different sizes
from the ADF.
Cancel 2-sided copy, or change the
paper size.
After a while, cancel the job.
Replace the handset.
This error is remedied automatically.
This error is remedied automatically.
This error is remedied automatically.
This error is remedied automatically.
This error is remedied automatically.
Enable PC-Fax TX.
4
4-17