Fueling; Adjusting The Cutter Bar - Stihl HL 100 Instruction Manual

English

Fueling

Preparations
Before fueling, clean the filler cap
N
and the area around it to ensure that
no dirt falls into the tank.
Position the machine so that the
N
tank cap faces up.
Opening the filler cap
Turn the cap counterclockwise until
N
it can be removed from the tank
opening.
Remove the cap.
N
14
Filling Up with Fuel
Take care not to spill fuel while fueling
and do not overfill the tank.
STIHL recommends you use the STIHL
filler nozzle for fuel (special accessory).
Fill up with fuel.
N
Closing the filler cap
Place the cap in the opening.
N
Turn the cap clockwise as far as
N
stop and tighten it down as firmly as
possible by hand.

Adjusting the Cutter Bar

135° Version
The angle of th cutter bar can be
adjusted upwards in 4 stages from 0°
(straight) to 45°, and downwards in 8
stages from 0° to 90° (right angle facing
down). There are therefore 13 possible
working positions.
There is also a special transport position
for the cutter bar.
WARNING
To reduce the risk of injury, carry out the
adjustment only when the cutting blades
are at a standstill – engine at idle speed.
HL 95, HL 95 K, HL 100, HL 100 K