Stihl FR 130 T Instruction Manual page 17

2
4
5
7
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Position the clamp (6) against the
N
drive tube.
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) in the holes
N
and screw them into the barrier bar
as far as stop.
Go to "Securing the Loop Handle".
N
Leave the barrier bar permanently
mounted to the loop handle.
FR 130 T
Mounting the Loop Handle without
Barrier Bar
7
8
3
6
7
1
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Position the clamp (6) against the
N
drive tube.
Line up the holes.
N
Fit the washers (8) on the
N
screws (7), and insert the screws in
the holes.
Screw the square nuts (1) onto the
N
screws (7) as far as stop.
Go to "Securing the Loop Handle".
N
Securing the Loop Handle
7
8
4
3
5
6
1
N
N
N
The sleeve (10) (not fitted on all models)
must be between the loop handle and
the control handle.
A
4
10
Secure the loop handle (4)
about 20 cm/8 in (A) forward of the
control handle (9).
Line up the loop handle.
Tighten down the screws firmly –
lock the nuts if necessary.
English
9
15