Buderus Logamax plus GB162-100 User Manual page 19
Condensing gas boiler
Hide thumbs
Also See for Logamax plus GB162-100:
- Instructions manual (16 pages) ,
- Replacement instructions manual (12 pages) ,
- Service instructions manual (100 pages)
Table of Contents
Advertisement
6.1.2 Manual Operation menu
In manual mode, the heating system can be operated
independent of a room controller (e. g. RC35).
Re-start manual operation after
switching on the heating system, so that
the system is permanently in operation
(especially if there is a risk of freezing).
Manual Operation menu
[\/2/4|
Step 1
Display value. Currently measured CH (boiler) flow temperature in °C.
Also see section 8.1, page 24.
Step 2
Activate manual operation?
Step 3
To activate manual operation: Press and hold the
[\/2/4}
Step 4
Display code: Operating phase: As soon as a flashing dot is shown in the right-hand
bottom corner of the display, manual operation is active. This means that the boiler is perma-
nently in heating mode. The maximum CH (boiler) flow temperature as set on the maximum
CH (boiler) flow temperature dial of the BC10 basic controller (control panel) now applies. The
"Heat request" LED lights up. DHW mode is possible during manual operation.
e
Step 5
Press the
[p/1.6}
Step 6
Display value. Currently measured system pressure in bar.
Also see section 8.1, page 24.
e
Step 7
Press the
[-/h/\}
Step 8
Display code: Operating phase: Also see section 8.3, page 24. The boiler is in
manual operation mode.
This means that the boiler is in heating mode while there is no heat request from the controller.
During manual operation the "Settings" menu (table 7 from step 3) can be used to temporarily
change the target boiler performance.
Note:If the boiler performance has been changed temporarily, this must be set again after
ending manual operation, according to the "Settings" menu (table 7, page 20).
e
Step 9
Press the
[\/2/4}
Step 10
Display value. Currently measured CH (boiler) flow temperature in °C.
Also see section 8.1, page 24.
Step 11
Has there been a power failure?
Step 12
Deactivate manual operation?
Step 13
To deactivate manual operation:
Press and hold the
table 6
Manual operation
Logamax plus GB162-65/80/100 - Subject to modifications resulting from technical improvements!
button.
button.
button.
d
button for more than 2 seconds until the dot disappears.
Operating the heating system
d
button for more than 5 seconds.
6
Yes:
step 3
No:
step 1
Yes:
step 1
No:
step 12
Yes:
step 13
No:
step 5
step 1
19
Hide quick links:
Advertisement
Table of Contents
