Samsung WF365BTB series Service Manual page 26

error Type
led
Overflow Error OE
Temperature
tE
sensor error
unbalance
dc
error
Foaming
Sd
detected
24 _ Troubleshooting
For usA
lCd
- Water is supplied continually because the water level
detection does not work.
- Because the drain hose is clogged and there is
an injection error (at a narrow section), the water
level detection does not work and water is supplied
continually.
- Water is supplied continually because of freezing or
because there is foreign material in the water supply
valve.
- This error may occur when the water level sensor is
degraded.
- The washing heater in the tub has an error. (Contact
error, temperature sensor fault)
- The connector is connected incorrectly or is
disconnected.
- If the water level sensor operates without water
because the water is frozen or for any other reason
and the temperature sensor engaged at the bottom to
prevent overheating for the washing heater detects a
temperature of 100 to 150 ˚C, the washing machine
turns the input power off.
- As laundry causes this error, check the laundry.
- Find the reason for the imbalance and solve it as
directed in the user manual.
- This occurs when too much foaming is detected. It is
also displayed while foaming is removed. When the
removal is finished, the normal cycle proceeds. "Sd"
or "SUdS" is displayed when too much foaming is
detected and "End" is displayed when the removal of
the foaming is finished.
(This is one of the normal operations. It is an error for
preventing non-sensing faults.)
Causes remarks
This error occurs
because the
water level
sensor terminal
is out of place.
Heater sensor
fault
: When the
connector is
connected
incorrectly or
has a wire
disconnected or
contact error