Assembly - Yamaha CLAVINOVA CVP-701 Owner's Manual

Assembly

Preparation Before Assembling
CAUTION
• Assemble the unit on a hard and flat floor with ample space.
• Be careful not to confuse or misplace the parts, and be sure to
install all parts in the correct orientation. Please assemble the
unit in accordance with the sequence described here.
• Assembly should be carried out by at least two persons.
• Be sure to use only the included screws of the specified sizes.
Do not use any other screws. Use of incorrect screws can cause
damage or malfunction of the product.
• Be sure to tighten all screws upon completing assembly of each
unit.
• To disassemble the unit, reverse the assembly sequence given
below.
Have a Phillips-head (+) screwdriver of the
appropriate size ready.
Remove foamed styrol pads from the package,
position them on the floor, then place A on top of
them. Position the pads so that they will not hide
the connectors on the bottom of A.
Remove all parts from the package and make sure you
have all of the items.
Main Unit
Foamed styrol pads
Back panel
Pedal Box
Bundled pedal cord inside.
Side panel
D D
A A
B B
C C
Side panel
E E
Assembly parts
F
6 x 20 mm x 4
G
4 x 12 mm x 2
H
4 x 20 mm x 4
J
6 x 16 mm x 6
Holder set
For details on how to set the
holders, refer to page 109.
Assembly
1
Attach C to D and E.
1 Untie and straighten out the bundled pedal cord.
Do not discard the vinyl tie. You will need it later
in step 5.
2 Secure D and E to C using four screws F.
D D
1
Headphone hanger
K
4 x 10 mm x 2
Headphone
hanger
Cord holders
x 2
Power cord
2 F
E E
C
CVP-701 Owner's Manual
113