Fitting The Harness - Stihl FS 100 RX Instruction Manual

English
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank. STIHL
recommends use of the STIHL filling
system (special accessory).
Closing the cliplock filler cap
Position the cap with the clip in an
N
upright position; the markings must
line up
Turn cap clockwise as far as it will
N
go (approx. 1/4 turn)
Fold the cliplock down so that it is
N
flush with the surface
If the cliplock is not flush with the surface
and the lug on the clip does not engage
entirely in the recess (arrow), the cap is
not properly closed and the steps
described above must be repeated.
20
Opening screw-type tank cap
Turn the cap counterclockwise until
N
it can be removed from the tank
opening.
Remove the cap.
N
Filling up with fuel
Take care not to spill fuel while fueling
and do not overfill the tank. STIHL
recommends you use the STIHL filler
nozzle (special accessory).
Closing screw-type tank cap
Place the cap in the opening.
N
Turn the cap clockwise as far as
N
stop and tighten it down as firmly as
possible by hand.

Fitting the Harness

The type and style of the harness
depend on the market.
The use of the harness is described in
the chapter on "Approved Combinations
of Cutting Attachment, Deflector, Handle
and Harness".
Shoulder strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is level with your
right hip when the machine is
attached.
Balance the brushcutter.
N
1
FS 100 RX