Sharp LC-37GD6U Operation Manual page 63

ent settinas
•
R,,%}~
Press MENU and the MENU screen displays.
"!
Press
~/~
to select "Setup".
Press
£./~
to select "Position
H
,
and then
~¥J
press ENTER.
Press
AfT
to select "H-Pos." or "V-Pas.".
,,~
i~ Press ~/~ to adjust the item to your desired
position.
rt
*#
@
For resetting all adjustment items to the factory preset
values, press A/V to select IIReset"
J
and then press
ENTER.
o
Adjustments are stored separately according to input
source. .
o
You can easily move the image position as shown on this
page, but when the power is switched off the image will
return to the previously memorized position.
Press
AfT /44f~
to move an image on the screen to
the desired position. Press ENTER to return to the initial
image position.
o
While pressing A/V 144/~, an on-screen image,
HAdjusting Position" displays to the desired position.
@
This setting cannot be stored. Once the TV shuts down or
enters standby model the setting is erased. To move the
picture around the screen again, you must perform the
above procedure again.
o
The image position setting using the steps on this page
can be stored. Select either according to your objectives.
o
HTV lI
,
HINPUT1", HINPUT2", HINPUT3" and IlINPUT4" can
each adjust the image position setting on this page. The
same for view modes.
@
An on-screen image from PC and card cannot be moved
around.
o
Even when the image fills the screen, its position can be
adjusted with this function.
@
Press ENTER to reset the image to original positions.
t
@-62
H..Pos..
Centers the image by moving it to the left
or right.
Centers the image by moving it up or
down.