Sharp LC-37GD6U Operation Manual page 58

Using external equipment
@
Power consumption during standby mode can be
minimized by changing the setting of the "Standby
Mode
Jt
in
,~'i.LINK
Setup".
e
When
LLINK
is not in use, select Hlnactive" in
HStandby Mode".
@
The function for automatically adjusting the recording
mode of connected D-VHS decks can be turned on
or off.
o
Since most of the currently available D-VHS decks
automatically recognize the transfer rates of the
pictures and sound being recorded and control the
recording mode accordingly,
you
should
always
set
this Mode to "Pass thru" in normal circumstances.
e
Depending on the D-VHS deck used and the type of
broadcast being recorded, this TV may not adjust
the recording mode properly. In this case, please
set the HRecording Mode
Jl
to "Pass thrun,
Press MENU and the MENU screen displays.
Press ~/~ to select HDigital Setup".
Press
A/T
to select HLLINK SetupJl, and then
press ENTER.
• 1'
•
Press MENU and the MENU screen displays.
Press
<tl/~
to select "Digital Setup".
Press A/V to select HLLINK Setup", and then
press ENTER.
Press A/V to select "Standby Mode", and
then press ENTER.
Press
~/~
to select "Active tJ or {'Inactive",
and then press ENTER.
Press
A/V
to select "Recording Mode", and
then press ENTER.
Press
~/~
to select "Auto" or "Pass thru",
and then press ENTER.
$
Normally, this should be set to "Pass thru".
"Active": Power continues to pass through the LLINK
circuit so data can be relayed.
Ulnactive": Power consumption is minimized during
stand-by mode. Data cannot be relayed at this
setting.
~,
o
When the main power of the TV is in standby mode
(POWER indicator lights off), i.LINK control commands
cannot be received from a D-VHS deck. This does not
change even if the HStandby Mode" is set to llActive". To
control the TV from a D-VHS deck, turn the TV pO\lver on
(POWER indicator lights up in blue).
$
Data cannot be relayed between i.LINK devices when all
the following conditions are met 1) More than one i.LINK
device is connected to the TV with i.LINK cables, 2)
tlStandby Modell is set to Hlnactive H
,
and 3) The power of
the TV is in standby mode (POWER indicator lights off).
When the TV is connected between two i.LINK devices in
series, select HActive" in HStandby Mode" or connect the
TV at an end of the series as shown in the diagram.
(Q§)
-57