Konica Minolta bizhub C450 User Manual page 361

Troubleshooting
Symptom
The stapling position
is not as expected.
The hole punch func-
tion cannot be speci-
fied.
The pages are not
punched.
The hole punch posi-
tion is not as expect-
ed.
The form is not printed
properly.
The image is not print-
ed properly.
Paper is not fed from
the specified paper
source.
The access number
cannot be specified.
C450
Probable Cause
The orientation setting is not cor-
rect.
Hole punching cannot be speci-
fied if "Booklet", "Transparency",
"Thick2", "Thick3", or "Envelope"
is selected.
If optional finisher FS-603 is in-
stalled, the punch kit PK-501 is
required.
Printed pages may be fed out
without being punched if the pa-
per is loaded into the paper
source with an incorrect orienta-
tion.
The orientation setting is not cor-
rect.
Available computer memory
space is not sufficient.
Available computer memory
space is not sufficient.
Paper will not be fed from the
specified paper source if that pa-
per source is loaded with paper of
a different size or orientation.
To specify access numbers, a
hard disk must be added in the
Option tab of the printer driver.
Action
Check the stapling position in the
printer driver setup dialog box.
Check each setting in the printer
driver.
Install the required optional finish-
er and enable it using the printer
driver.
Check the orientation setting.
Check the punch position on the
Layout tab of the printer driver
setup dialog box.
Simplify the form to reduce the
data size.
Simplify the image to reduce the
data size.
Load the paper source with paper
of the appropriate size and orien-
tation.
Add a hard disk in the Option tab
of the printer driver.
11
11-4