81170_2.BOOK Page 4 Thursday, July 19, 2001 2:36 PM
2-4
2
4
Top view
Figure 2-1: Surface Mounting Arrangement
Pole Mounting
Refer to Figure 2-2 :
1. Screw the pole mount base to a suitable pole or rail mount bracket,
having an industry standard 1in 14TPI thread, until secure.
2. Pass the cable through the centre hole of the pole mount base (A)
or through the cable exit hole alongside the centre hole (B) or
insert the cable into the side exit channel (C).
3. Check the cable is positioned correctly and secure the GPS
Receiver to the pole mount base using the two screws provided.
If the cable is to exit from the side of the GPS Receiver through
the side channel, remove the two plastic tabs (1) obstructing the
cable channel.
Note: Failure to remove the plastic tabs from within the cable chan-
nel could result in cable damage.
Raystar 120 GPS Receiver
3
2
4
Underside view
1
3
D4725_1