Page 1
Distributed by Any reference to Raytheon or RTN in this manual should be interpreted as Raymarine. The names Raytheon and RTN are owned by the Raytheon Company.
Installation Guide IMPORTANT NOTICE This device is only an aid to navigation. Its accuracy can be affected by many factors, including equipment failure or defects, environmental conditions and improper handling or use. It is the user’s responsibility to exercise common prudence and navigational judgement, and this device should not be relied upon as a substitute for such prudence and judgement.
There are no user serviceable parts in any Raytheon product. • Always report any EMC related problem to your nearest Raytheon dealer. We will use any such information to improve our quality standards. Raystar 114...
Disposal Note: Care should be taken when disposing of this equipment as a Lithium battery is fitted internally. Local regulations may apply and must be adhered to. Raystar 114 12 Parallel channels 1575.42 MHz +/- 1 MHz (C/A code), L1...
Page 8
Installation Guide Differential Beacon Receiver Frequency Range: MSK Bit Rate: Frequency Resolution: Sensitivity: Frequency Selection: 283.5 to 325.0 kHz 100, 200 bps 0.5 kHz 2.5 mV/ m @10dB SNR @ 100 bps Automatic / Manual (user-selectable)
Page 9
4. Raystar 114 Installation The Raystar 114 is designed to receive the signals emitted from the satellites in a direct path. Ideally, the unit should be mounted upright in a location that is open and clear of any masts, search lights, or other structures that could block the line-of-sight reception of the antenna unit.
Installation Guide Ideally the cable should be run in a manner so that it can be hidden from view and, if possible, be in a direct path to the point of connection. It is important to keep the cable separated from other shipboard cables as much as possible to prevent interference pick-up.
Mounting The Raystar 114 can be mounted on a pole. Alternatively, you can use a surface mount kit supplied by your local marine dealer. The aluminium base of the Raystar 114 has been chromation treated to add toughness, resistance to wear and tear and resistance to corrosion of the assembly.
Page 12
As with all onboard marine equipment, the installer should ensure that the power supply connection to the RayStar 114 is adequately protected by a suitably rated fuse or circuit breaker. This will be provided, typically, by connection via a fused display unit.
Using a Connector Block When connecting a RayStar 114 into an existing instrument system or to certain Raytheon chartplotters (eg. RayChart 520 or RL70RC) a connector block can be used to connect into the SeaTalk bus. If dc power is not already available via an existing SeaTalk instrument, a connector block can be used to supply power to the SeaTalk bus for this and other applications.
Note: A SeaTalk Auxiliary Junction Box, which satisfies the above requirements, is available from your Raytheon Marine agent or is supplied with certain chartplotter products. For further technical information, please visit the Raytheon Marine web site at: www.raymarine.com NMEA Sentences Output GPGGA PRAYA...
United States of America Raytheon Marine Company Recreational Products 676 Island Pond Road Manchester, NH 03109-5420 U.S.A. UK, Europe, Middle East, Far East Raytheon Marine Company Recreational Products Anchorage Park, Portsmouth PO3 5TD, England Purchased from Dealer Address Installed by Commissioned by Owner’s name Mailing address...