Table of Contents
Advertisement
Option settings
ID number setting
The projector has an ID number setting function that helps the user to control two or more projectors either
simultaneously or separately with a single remote control. The ID number is set to "ALL" by default. Hence the
ID number need not be set when only one projector is used.
Procedure of setting
MAIN MENU
PICTURE
POSITION
LANGUAGE
OPTION
TEST PATTERN
SIGNAL LIST
:MENU SELECT
ENTER:SUB MENU
OPTION
ID
SETTING
LAMP1 RUNTIME
LAMP2 RUNTIME
LAMP SELECT
LAMP POWER
LAMP COOLING TIME SHORT
RS232C SETTING
RGB2 SELECT
OSD POSITION
:MENU SELECT
:CHANGE
• The ID number can be set to "ALL", or selected from "1" to "64".
Note
• If the projectors are given ID numbers, their remote controls must be assigned the same ID numbers,
respectively.
• If the ID number of a projector is set to "ALL", it can be controlled by the remote control or the PC with
any ID number.
If multiple projectors are used and some of them have their IDs set to "ALL", they cannot be controlled
separately from the projectors with other ID numbers.
For details on remote control ID setting, see page 16.
70
2
FRONT-F
57h
60h
DUAL
HIGH
RGB1 OUT
1
Press the "MENU" button.
The MAIN MENU screen will be displayed.
Select "OPTION" with the
buttons.
Press the "ENTER" button.
The OPTION screen will be displayed.
Select "ID" with
change the value with
(ALL, 1, 2, ...64).
Press the "MENU" button twice.
This concludes the setting procedure and the on-
screen indications disappear and the normal
screen appears again.
buttons and
buttons
Advertisement
Table of Contents
