Table of Contents
Advertisement
Adjusting the picture
To set the sRGB compliant picture
sRGB is the international color reproduction standard (IEC61966-2-1) established by IEC (International
Electrotechnical Commission).
Perform the following setting procedure to reproduce the higher-fidelity picture in compliance with sRGB.
1. Set color matching adjustment to "OFF".
2. Press the
Set to "NATURAL" with the
3. Select the "COLOR" with the
Press the STD (standard) button on the remote control to restore the factory default.
Follow the same procedure to restore the factory default for "TINT", "COLOR
TEMP." and "GAMMA".
• sRGB is only enable when RGB signals are being input.
Note
To input BETACAM with YC
When receiving a picture of 480i with analog component signal YCbCr input, the input level of Cb and Cr can be
switched.
MAIN MENU
PICTURE
POSITION
LANGUAGE
OPTION
TEST PATTERN
SIGNAL LIST
:MENU SELECT
ENTER:SUB MENU
PICTURE
FORMAT
PULLDOWN MODE
COLOR MATCHING
:MENU SELECT
:CHANGE
• This function is available only when input signals are supplied through the analog RGB input module
Note
(ET-MD95RGB). RGB1, RGB2 inputs do not support BETACAM signals.
• This function can be switched only when receiving the picture of 480i in the YCbCr mode.
It cannot be switched when receiving the picture of signals other than RGB-REALITY mode, RGB
mode and 480i.
• SMPTE is the factory default.
56
buttons on the "PICTURE" menu and select the "PICTURE MODE".
buttons.
SMPTE
AUTO
USER
buttons.
C
b
Press the "MENU" button.
The MAIN MENU screen will be displayed.
Select "PICTURE" with the
buttons.
Press "ENTER" button.
The PICTURE screen will be displayed.
Select "FORMAT" with the
buttons.
Switch the signal format with the
buttons.
• This toggles between SMPTE and BETACAM.
<Signal level>
Format
SMPTE
BETACAM
480i
r
Y
Synchronous part
700 mV
300 mV
714 mV
286 mV
C
, C
b
r
±350 mV
±504 mV
Advertisement
Table of Contents
