Memory Save, Memory Load; Projecting Srgb-Compatible Pictures; Signal Mode - Panasonic PT-AE700 Operating Instructions Manual

MEMORY SAVE
Press the ENTER button to display
the "MEMORY SAVE" menu.
M E M O R Y S A V E
M E M O R Y 1
M E M O R Y 2
M E M O R Y 3
S E L E C T E N T E R E S C
The settings adjusted in "PICTURE"
menu can be saved. Press the F or
G button to select the number
("MEMORY 1/2/3") in which you
want to save the setting, and then
press the ENTER button.
The confirmation screen will then be
displayed. Press the I or H button
to select "OK" and then press the
ENTER button.
The current picture setting will be
saved.
M E M O R Y S A V E
O K C A N C E L
NOTE:
B You can save up to 3 settings
for each of the 2 signal groups
described below (up to 6
settings can be saved).
S-VIDEO, VIDEO, YP P ,
B R
SCART, HDMI (except for
VGA480 signals) and 1 125
(1 080)/60i and 1 125
(1 080)/50i signals from PCs
VGA480 HDMI signals and PC
[except for 1 125 (1 080)/60i
and 1 125 (1 080)/50i signals]
42-E
NGLISH
MEMORY LOAD
Press the ENTER button to display
the "MEMORY LOAD" menu.
(If any setting is not saved in the
"MEMORY SAVE" menu, the
"MEMORY LOAD" menu will not be
displayed.)
Refer to page 35 on how to retrieve
the saved settings.
TV-SYSTEM
(S-VIDEO/VIDEO only)
T V - S Y S T E M A U T O
[
N T S C
[
N T S C 4 . 4 3
[
P A L
[
P A L - M
[
P A L - N
[
S E C A M
This should normally be set to
"AUTO". If the signal is of such poor
quality that the correct format
cannot be automatically
distinguished, change the setting
manually to the required TV system.
NOTE:
B When set to "AUTO", the
projector automatically
distinguishes between
NTSC/NTSC 4.43/PAL/PAL60/
PAL-M/PAL-N/SECAM signals.

SIGNAL MODE

(PC/YP P /HDMI only)
B R
This displays the type of signal
which is currently being projected.
Refer to the list on page 58 for
details on each type of signal.
Projecting sRGB-
compatible pictures
sRGB is an international colour
reproduction standard (IEC61966-2-
1) established by the International
Electrotechnical Commission (IEC).
If you would like the colours in
sRGB-compatible pictures to be
reproduced more faithfully, make
the following settings.
# Press the F or G button to
select "PICTURE MODE", and
then press the I or H button
to select "NATURAL".
$ Press the NORMAL button on
the remote control unit.
% Press the F or G button to
select "LAMP POWER" in the
"OPTION" menu, and then
press the I or H button to
select "HIGH".
E -43
NGLISH