Setting Projector Id Number To Remote Control; Using The Remote Control As A Pc Mouse - Panasonic PT-DW5000UL Operating Instructions Manual

Dlp based projector for commercial use
Hide thumbs Also See for PT-DW5000UL:
Table of Contents

Advertisement

Setting projector ID number to remote control

Every projector has its ID number and the ID number of the controlling projector must be set to the remote
control in advance so that the user can operate the remote control. The ID number of the projector is set to
"ALL" on shipping, and use the ID ALL button of the remote control when using only a single projector.
Procedure of ID setting
Change the position of the operation mode selector switch to "Computer".
Press the ID SET button, and within five seconds use the number (0 to 9) buttons to
enter the 2-digit ID number set by the projector.
Change the position of the operation mode selector switch to "Projector".
However, if the ID ALL button is pressed, the projector can be controlled regardless of the ID number of the
projector (simultaneous control mode).
• Do not press the ID SET button accidentally or carelessly because the ID number on the remote
Attention
control can be set even when no projector is around.
If the ID SET button is pressed, the ID number goes back to the one set before pressing the ID
SET button unless a numeric button is pressed within five seconds after the ID SET button is
pressed.
• Your specified ID number is stored in the remote control unit unless another one is specified later.
However, the stored ID will be erased if the batteries of the remote control are left exhausted.
When the dry cells are replaced, set the same ID number again.
• When specifying the ID number, enter a 2-digit number even if the ID has only one digit.
(Example: set "02" if the ID number is "2.")

Using the remote control as a PC mouse

Left click
( ) button
Click button
• To use the remote control as a mouse, please purchase an optional wireless mouse receiver
Note
(model No.: ET-RMRC2).
PAGE UP button
ENTER button
Right click ( ) button
PAGE DOWN button
Operation mode
selector switch
Operation mode selector switch
Put the knob to the Computer position.
• ENTER button
Pressing the front, rear, left and right edges of the
button moves the mouse cursor up, down, left and
right.
• Right click (
) button
This button can be used as the right mouse button.
• Left click (
) button
This button can be used as the left mouse button.
• PAGE UP button
This button can be used as the Page Up button on
the PC keyboard.
• PAGE DOWN button
This button can be used as the Page Down button on
the PC keyboard.
• Click button
This button can be used as the left mouse button.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents