Yamaha YSP-40D Owner's Manual page 95

OSD SET (OSD settings)
Use to adjust the display position and to set the display
time of the OSD.
B)OSD SET
.
OSD SHIFT;;;;;;;;;;0
OSD DISPLAY TIME;;;ON
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
OSD SHIFT (OSD shift)
Use to adjust the vertical position of the OSD. Adjust
toward the – (minus) direction to raise the position of the
OSD, and adjust toward the + (plus) direction to lower it.
Choices: –5 to +5
Initial setting: 0
OSD DISPLAY TIME (OSD display time)
Use to set the interval for which the OSD screen is
displayed after an operation.
Choices: ON, 10s, 30s
• Select ON to show the OSD screen constantly.
• Select 10s to turn off the OSD screen 10 seconds after
an operation.
• Select 30s to turn off the OSD screen 30 seconds after
an operation.
y
The OSD display time setting is available for your iPod (see
page 58).
UNIT SET (Unit settings)
Use this to change the display unit of measurement.
Choices: METERS, FEET
C)UNIT SET
p
METERS
p
[ ]/[ ]:Select
[ENTER]:Return
• Select METERS to enter distances in meters.
• Select FEET to enter distances in feet.
Note
If you change this setting, the adjusted sound beam settings may
change.
p
FEET
MANUAL SETUP
93
En