Honda 2007 Civic Hatchback Owner's Manual page 454

NOTE:
The power supply of the air
compressor is limited to the 12 volt
DC accessories of the vehicle.
Directions
Before using the air compressor,
drive your vehicle to the road
shoulder and stop in a safe place that
is far away from the traffic lanes.
Step 1.
Remove the valve cap from a flat
tyre and securely connect the air
compressor hose to the valve.
Step 2.
Connect the power plug of the air
compressor to the socket of the
cigarette lighter.
Step 3.
Turn the ignition switch to the
ACCESSORY (I) position. Turn on
the air compressor switch and
inflate the tyre to the specified air
pressure. Check the tyre pressure
by using the air pressure gauge on
the compressor.
Turn off the switch on the air
compressor before checking the air
pressure.
Step 4.
When the tyre is inflated to
specified air pressure, disconnect
the power plug from the cigarette
lighter socket. Make sure not to
allow air to leak from the tyre.
Then install and tighten the valve
cap securely.
Honda TRK (For some types)
Sealant Extraction
(For a Honda dealer)
Be careful not to spill sealant from a
tyre.
1. Remove a tyre and a wheel from
the vehicle.
Deflate tyre pressure.
2. Cut the valve off with a knife.
Taking Care of the Unexpected
CONTINUED
451