Yamaha 2011 Star XV250A Owner's Manual page 47

TIP
Skip steps 4–6 if the oil filter element is
not being replaced.
4. Remove the oil filter element cover
by removing the screws.
1. Screw
2. Oil filter element cover
5. Remove and replace the oil filter
element and O-ring.
PERIODIC MAINTENANCE AND ADJUSTMENT
1. Oil filter element
2. O-ring
6. Install the oil filter element cover by
installing the screws, then tighten-
ing them to the specified torque.
Tightening torque:
Oil filter element cover screw:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Make sure that the O-ring is properly
seated.
7. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
7-11
Tightening torque:
Engine oil drain bolt:
34 Nm (3.4 m·kgf, 25 ft·lbf)
8. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 9-1.
Oil quantity:
With oil filter element replacement:
1.60 L (1.69 US qt, 1.41 Imp.qt)
Without oil filter element replace-
ment:
1.40 L (1.48 US qt, 1.23 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
7
ECA11620