Yamaha 2011 Star XV250A Owner's Manual page 20

INSTRUMENT AND CONTROL FUNCTIONS
Right
4
1. Engine stop switch "ENGINE STOP"
2. Hazard switch "HAZARD"
3. Start switch "START"
Pass switch "PASS"
Press this switch to flash the headlight.
Dimmer switch "LIGHTS"
Set the switch to "HI" for the high beam
and to "LO" for the low beam.
Turn signal switch "TURN"
To signal a right-hand turn, push this
switch to the right. To signal a left-hand
turn, push this switch to the left. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "HORN"
Press this switch to sound the horn.
Engine stop switch "ENGINE STOP"
Set this switch to "RUN" before starting
the engine. Set this switch to "OFF" to
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU12360
Start switch "START"
Push this switch to crank the engine
EAU12410
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
EAU12440
Hazard switch "HAZARD"
With the key in the "ON" position, use
this switch to turn on the hazard lights
(simultaneous flashing of all turn signal
lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
EAU12510
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU12650
gine not running, otherwise the bat-
tery may discharge.
EAU12691
EAU12752
4-3
ECA10061