1-4. Opening and closing the windows and moon roof
■
When the power window does not close normally
If the jam protection function is operating abnormally and a window cannot
be closed, perform the following operations using the power window switch
on the relevant door.
●
After stopping the vehicle, the window can be closed by holding the
power window switch in the one-touch closing position while the
"ENGINE START STOP" switch is turned to IGNITION ON mode (vehi-
cles with smart key system) or the engine switch is turned to the "ON"
position (vehicles without smart key system).
●
If the window still cannot be closed even by carrying out the operation
explained above, initialize the function by performing the following proce-
dure.
STEP
1
Hold the power window switch in the one-touch closing position.
Continue holding the switch for a further 6 seconds after the win-
dow has closed.
STEP
2
Hold the power window switch in the one-touch opening position.
Continue holding the switch for a further 2 seconds after the win-
dow has opened completely.
STEP
3
Hold the power window switch in the one-touch closing position
once again. Continue holding the switch for a further 2 seconds
after the window has closed.
If you release the switch while the window is moving, start again from the
beginning. If the window continues to close but then re-open slightly even
after performing the above procedure correctly, have the vehicle inspected
by your Toyota dealer.
■
Customization
Settings (e.g. Rear window Auto Up/Down) can be changed.
(Customizable features P. 519)
98
VENZA_OM_OM73019U_(U)