Honda 1999 Odyssey Owner's Manual page 99

HomeLink Universal Transmitter
3. Press the Training button on the
motor/control unit until the
Training light comes on, then
release it.
4. Press and release the desired
button on the HomeLink
transmitter.
5. Press and release the HomeLink
transmitter button again. This
should turn off the training light
on the motor/control unit. (Some
systems may require you to press
and release the button three times.)
6. Press the transmitter button again.
It should operate the garage door.
Instruments and Controls
Erasing Codes
To erase the codes stored in all three
buttons, press and hold the two
outside buttons until the red light
begins to flash, then release the
buttons.
You should erase all three codes
before selling the vehicle.
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
This device complies with DOC
regulations in Canada.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's
authority to operate the equipment.