Selection Of Manual Mode - Subaru 2009 Forester Owner's Manual

7-18
Starting and operating
& Selection of manual mode
With the vehicle either moving or station-
ary, move the selector lever from the "D"
position to the manual gate then move it to
the "+" end or "−" end of the manual gate
to select manual mode.
1) Upshift indicator
2) Downshift indicator
3) Gear position indicator
When manual mode is selected, the gear
position indicator and upshift indicator
and/or downshift indicator on the combi-
nation meter illuminate. The gear position
indicator shows the currently selected
gear in the 1st-to-4th-gear range. The
upshift and downshift indicators show
when a gear shift is possible. When the
upshift indicator " " is illuminated, up-
shifting is possible. When the downshift
indicator " " is illuminated, downshifting
is possible. When both indicators are
illuminated, upshifting and downshifting
are both possible. When the vehicle stops
(for example, at traffic signals), the down-
shift indicator turns off.
Gear shifts can be performed by using the
selector lever.
Using the selector lever
Shift to the next-higher gear by briefly
pushing the selector lever toward the "+"
end of the manual gate.
Shift to the next-lower gear by briefly
pulling the selector lever toward the "−"
end of the manual gate.
NOTE
Please read the following points care-
fully and bear them in mind when using
the manual mode.
. If you attempt to shift down when
the engine speed is too high, i.e., when
a downshift would push the tachometer
needle beyond the red zone, beeps will
be emitted to warn you that the down-