Panasonic CF-W8 Series Reference Manual page 129

Troubleshooting (Advanced)
Problems with Wireless LAN (only for models with wireless LAN)
Access point is not detected
Shorten the distance between the computer and the access point, and try the detection again.
It may take some time before the access point is displayed in [Available Networks]. Wait for a moment.
Confirm the following settings:
• [Wireless LAN] in the [Advanced] menu of the Setup Utility
Confirm that [Wireless LAN] is set to [Enabled]. (
• Wireless device off:
Confirm that /
Confirm whether the Intel
[start] - [Control Panel] - [Add or Remove Programs].
If it has not been installed, input [c:\util\drivers\wlan\WiFi\XP\x32\Install\install.bat] in [start] - [Run] to install.
• Wireless LAN power supply
If is displayed on the notification area, slide the wireless switch to the right (ON).
• IEEE802.11a settings
Even if the wireless LAN is on, IEEE802.11a may be set to disable. If IEEE802.11a is to
be used, change this setting to enable. (
This computer uses channels 1 through 11
nel being used by the access point.
*3
In the case of wireless communications, the frequency band being used can be divided into
segments, so that different communications can be conducted on each band segment. A "Channel"
refers to the individual frequency bandwidth divisions.
/ is displayed on the notification area.
®
PROSet/Wireless Software is installed using the following menu.
page 92)
*3
when using IEEE802.11b/g. Check the chan-
page 100)
129
CF-F8 Series
CF-W8/CF-T8 Series
WIRELESS