Panasonic aw-e350p Operating Instruction page 52

3. Noise Suppress Level Setting
[Noise Suppress: OFF, LOW, HIGH]
Screen noise can be reduced when Detail Level
setting ( -2) is at HIGH or LOW.
4. Clean DNR Setting [Clean DNR: HIGH, LOW, OFF]
This enables the clean DNR effect to be selected.
5. 3D-DNR Setting [3D-DNR: OFF, Low, Mid, High]
This enables the 3D-DNR effect to be selected.
K When "Mid" or "High" is selected, the noise is
reduced but lag increases.
6. DTL Flesh Tone Setting
[DTL Flesh Tone: LOW, MID, HIGH]
LOW: The roughness of the flesh tones is minimized.
MID: This is the standard setting.
HIGH: The outline compensation for the flesh tones is
accentuated.
Other Set Display
1. Contrast Adjustment
[Contrast (Gamma): LOW, MID, HIGH]
The contrast can be adjusted to any of three levels.
2. Electronic Shutter Setting
[Shutter Speed: OFF, 1/100 to 1/10 000, S/Scan, Auto ND]
OFF: Electronic shutter is turned off.
1/100, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000, 1/10 000:
Electronic shutter operates at one of these speeds
as selected.
S/Scan (Synchro Scan): Electronic shutter operates
at the speed set with the electronic shutter
synchro-scan setting ( -1).
Auto ND: Electronic shutter is controlled to
automatically adjust the luminance. (ELC)
Notes
• In case of using the RCU, none of the shutter
speeds — 1/250, 1/2 000, 1/4 000, and
1/10 000 can be selected.
• If the lens iris switch is at M (Manual) when
operating the camera alone or when the lens
iris selector switch (IRIS button) on the RCU,
ROP or multi hybrid control panel is at AUTO,
Auto ND may not function. Set the lens iris
switch to A (Auto).
• Flickering may increase at Auto ND under
fluorescent lights.
• Auto ND is automatically selected if Auto ND
(ELC) setting is set to ON.
- 52 -