Manual Tuning; Tuning The Television To A Vcr - Panasonic QUINTRIX TX-86PW300A Operating Instructions Manual

This Television has been factory tuned to all the major city channels. Use this tuning procedure only if you wish to
reset individual Programme Numbers. The television should be switched ON and the TV/AV Switch set to TV.
Using the Front Panel
1. Push the F button repeatedly until the Tuning
Menu is reached.
2. Push the -/\/ or +//\ Button to access the
Tuning Menu.
3. Push the F button to access the Manual Tune.
4. Push the -/\/ or +//\ button to select the
Manual Tune.
Manual tuning (Front panel)
- , + : Search
STR : To store
F : To exit
STR F
5. Push the TV/AV button to switch to "Change
Programme".
6. Use the -/\/ or +//\ buttons to select the
programme location number to tune.
7. Push the TV/AV button to switch to "Search".
8. Push the -/\/ or +//\ Button to start the search.
9. The television will automatically search for the
next broadcast signal. As each station is
found the search will stop. If you do not want
this station restart the search.
10. Push the STR to store the selected station.
11. Push the F button to return the television to
the Tuning Menu.
12. To return the television to normal operation
push the TV/AV button on the remote control
or repeatedly push the F button until the
volume display appears.
Note: Pushing the

Tuning the Television to a VCR

1. Turn the VCR On and either start a known tape playing or set the VCR Test Signal, if fitted, to On
(refer to the VCR operating instructions).
2. Repeat steps 2, 3 and 4 of the Manual tuning procedure above. The television will treat the VCR as if
it was a normal television broadcast station.
NOTES:
1. The antenna lead must be connected to the VCR and the VCR RF-Out must be connected to the TV
RF-In. Please refer to page 37.
2. The picture and sound quality are usually much better if the VCR is connected using the AV
Terminals. Please refer to page 37 or 38.
-/\/ +//\ TV/AV
button at any time will stop the Manual tuning and return you to normal viewing.
Using the Remote Control
1. Push the Set Up (
2. Push the or
Tuning Menu.
3. Push the or button to access the Tuning
Menu.
4. Push the or
Manual Tune.
29
5. Push the or button to access the Manual
Tune.
6. Push the or
programme location number to tune.
7. Push the or button to start the search.
8. The television will automatically search for the
next broadcast signal. As each station is found
the search will stop. If you do not want this
station restart the search.
9. Push the to store the selected station.
10. Push the Set Up (
television to the Tuning menu.
11. Push the button to return the television to
normal operation.
Tuning Menu

Manual Tuning

) button.
button to select the
button to select the
button to select the
) button to return the
27