Panasonic WJ-NT314 Network Operating Instructions page 6

u B/W button (*2)
Click the desired button to switch color (colour) of
the displayed images between color (colour) and
B/W.
: Images will be displayed in B/W (black and
white).
: Images will be displayed in color (colour).
: Activates Auto 1 mode. (The camera
selects black and white mode if the picture
is dark, or color mode if the picture is
bright enough.) If the camera has only one
AUTO mode, click this button.
: Activates Auto 2 mode. (The camera
detects the light source type to prevent
malfunction. This setting is applicable
when using a near-infrared light source in
a dark place.)
i ZOOM buttons (*2)
: Click this button to adjust the zoom ratio to
the WIDE side.
: Click this button to set the zoom ratio to
x1.0.
: Click this button to adjust the zoom ratio to
the TELE side.
o FOCUS buttons (*2)
: Click this button to adjust the focus auto-
matically.
: Click this button to adjust the focus to the
NEAR side.
: Click this button to adjust the focus to the
FAR side.
!0 AUTO MODE (*2)
Select an operation from the pull-down menu and
click the [START] button. The selected operation will
start.
Click the [STOP] button to stop the operation.
The selected operation will stop when the camera
(panning/tilting/zooming/focusing) is operated.
Auto pan: Automatically pans between the start
position and the end position set in advance.
Even when the camera is operated for zooming
or focusing, the camera continues panning.
Sort: Sequentially switches between preset posi-
tions counterclockwise, starting from the camera
home position.
Sequence: Automatically moves to the preset posi-
tions orderly (start from the lowest preset posi-
tion number).
6
Patrol: Operates the camera in accordance with
patrol function settings.
Auto track: Performs auto track when the camera
supports auto track (AUTO TRACK).
Notes:
• To activate "Auto pan", "Sort", "Sequence", or
"Patrol", it is required to perform the settings on the
SETUP MENU of camera in advance. ( page 28)
• To check if the camera supports auto track, refer to
the operating instructions of the camera.
!1 Control pad/buttons (*2)
: Left-click on the control pad or buttons
to adjust the horizontal/vertical position
of the camera (panning/tilting).
Panning/tilting speed will be faster if a
clicked point gets farther from the center
point of the control pad.
It is also possible to pan/tilt the camera by dragging
the mouse.
When the upper half area of the control pad is right-
clicked, the displayed image will be zoomed in.
When the lower half area is right-clicked, the dis-
played image will be zoomed out on. When the left
half area is right-clicked, the focus will be adjusted to
the NEAR side. When the right half area is right-
clicked, the focus will be adjusted to the FAR side.
!2 BRIGHTNESS buttons (*2)
: The displayed image will be darker.
: The adjusted brightness will return to the
default brightness.:
: The displayed image will be brighter.
Note:
When the BRIGHTNESS buttons are clicked while
the camera is at the preset position, the adjusted
brightness will automatically be registered for the
current preset position.
!3 Preset (*2)
Select a preset position from the pull-down menu
and click the [GO] button. The camera will move to
the selected preset position. When "Home position"
is selected, the camera will move to the home posi-
tion.
To activate preset positions and home position, it is
required to configure the settings on the SETUP
MENU of camera in advance. ( page 28)