Table of Contents
Advertisement
6. Remove knock out from bottom of firebox by using a
hammer (Figure 16.2 on page 16).
7. Install ash door assembly by sliding the rod at an angle
into the slot on the left side (Figure 16.3 on page 16).
8. Slide the ash door over the 8 screws protruding from the
bottom of the appliance. Secure with nuts and washers
using 7/16 socket wrench (Figure 16.3 on page 16).
9. Install ARS latch by sliding latch assembly over 2 threaded
studs protruding from the bottom on the left hand side of
the appliance. Secure by using two nuts use 7/16 socket
wrench (Figure 17.1 on page 17).
10. Add knob to handle rod (Figure 17.2 on page 17).
11.Use 2 bolts and 2 flange nuts to secure ARS channel
using 3/8 open end wrench and 7/16 socket wrench
(Figure 17.3 on page 17).
Installing Queen Anne Leg ARS Kit
1. Follow Beginning installing the ARS system instructions
provided on page 18.
2. Install ARS Spacer on left hand side with one bolt using
phillips head screwdriver (Figure 17.4 on page 17).
3. Install leg brackets and ash drawer using four screws and
phillips head screwdriver .
• Start bottom two bolts through ash drawer, leg mount and
into the bottom of the appliance (Figure 19.1).
• Align top holes and repeat; secure all four bolts.
4. Install legs onto mounting brackets making sure the legs
are up against the bracket and secure with bolts and
washers using a 3/8 open end wrench (Figure 19.2).
5. Install leveling bolts into 2 legs; these leveling legs should
be in opposite corners (Figure 19.2).
6. Carefully stand stove up and place in desired location.
7. Use leveling bolts on legs to stabilize and level stove
(Figure 19.3).
Finishing the ARS Installation
1. Replace front 3 bricks that were removed (Figure 19.4).
2. Install the ash drawer to ASH Removal.
3. Install ARS access cover inside of ARS Channel that is
located inside the firebox (Figure 19.4).
Caution!
CHECK BAFFLE BOARDS & CERAMIC BLANKET!
•
Verify that the baffle boards and ceramic blanket are
in their proper locations.
•
It is important that the baffle boards and ceramic blan-
ket are in correctly installed for proper burn safety.
September 27, 2016
Lay appliance flat on
its back on protective
padding or pallet
Figure 19.1
Leg Brackets
Figure 19.2
Figure 19.3
ARS Access
Figure 19.4
7038-206F
5700 STEP TOP ACC
Align top holes
and repeat; secure
Ash Removal Box
Insert 2 bottom screws loosely
Leveling Legs at
Opposite Corners
Cover
Reinstall 3
Front Bricks
Back into Firebox
Ash Drawer
19
Advertisement
Table of Contents
