Thermostat - Rheem 96v series Installation Instructions Manual

REVERSING ELECTRICAL CONNECTION & THERMOSTAT
5. Move the junction box to the opposite side of the cabi-
net. Install using the two screws removed in step 3
above. Note that all screws penetrating the junction
box must be blunt – no sharp tipped screws can be
used.
6. Replace the plug from the opposite of the furnace (the
new j-box location) to the old j-box location and install
qty=2 1/4" plugs from parts bag in empty screw holes
in old location of j-box into the mounting screw holes
in the old junction box location.
7. Using a flat screwdriver, squeeze the retaining arms
on the door switch and gently pry the door switch from
it's opening as shown in Figure 39.
8. Install the door switch in the same opening on the op-
posite of the furnace and reconnect the electrical con-
nectors (removed in Step 2) to the door switch.

THERMOSTAT

The room thermostat must be compatible with the furnace.
See manufacturer's thermostat spec sheet for compatabil-
ity concerns. Generally, all thermostats that are not of the
"current robbing" type are compatible with the integrated
furnace control. The low voltage wiring should be sized as
shown.
FIGURE 41
LINE VOLTAGE CONNECTIONS
ELECTRICAL WIRING
NOTE: Do not use 24 volt control wiring smaller than No.
18 AWG.
Install the room thermostat in accordance with the instruc-
tion sheet packed in the box with the thermostat. Run the
thermostat lead wires inside the blower compartment and
connect to low voltage terminals as shown on the wiring
diagram. Never install the thermostat on an outside wall or
where it will be influenced by drafts, concealed hot or cold
water pipes or ducts, lighting fixtures, radiation from fire-
place, sun rays, lamps, televisions, radios or air streams
from registers.
FIGURE 40
ISOLATION RELAY
ST-A1194-60-00
ST-A1194-59-00
77