Panasonic AJ-HD1200A Operating Instructions Manual page 35

Setup menus
BASIC
Item
Superimposed
No. No.
display
020 SYS FORMAT
0000
0001
022 PB FORMAT
0000
0001
023 FORMAT SEL
0000
0001
0002
0003
0004
0005
0006
030 HD FREQUENCY
0000
0001
031 OUT REF
0000
0001
0002
0003
" " indicates the factory setting.
Setting
Superimposed
display
For setting the format in which to record or play back the signals including the HD
REF signals.
1080i 0: 1080i mode
720p 1: 720p mode
For setting the format in which to play back the tape.
MANUAL 0: The tape is played back in the format selected by the menu item No.020 [SYS
FORMAT] setting.
AUTO 1: The tape is played back in the format selected by the format in which the tape
was recorded.
For selecting the format when MANUAL is selected as the menu item No.022 [PB
FORMAT] setting.
HD-LP 0: The DVCPRO HD-LP format is selected, and the format follows the menu item
No.020 [SYS FORMAT] setting.
HD-SP 1: The DVCPRO HD format is selected, and the format follows the menu item
No.020 [SYS FORMAT] setting.
422 2: The DVCPRO50 (422) format is selected.
411 3: The DVCPRO (411) format is selected.
420p 4: The DVCPROP (420p) format is selected.
DV 5: The DV format is selected.
DVCAM 6: The DVCAM format is selected.
For setting the field frequency.
59/23 0: The field frequency is set to 59.94/23.98 Hz.
60/24 1: The field frequency is set to 60/24 Hz.
<Note>
The field frequency which is set here takes effect only when there is no input which
supports the OUT REF setting.
If there is an input which supports the setting, the field frequency is consistent with
the field frequency of input.
For selecting the video output reference.
AUTO 0: The REF signal (HD/SD) which is input to the REF connector is automatically
identified and serves as the reference.
If no signal is supplied to the REF connector, the HD serial input signal serves
as the reference.
If neither the REF input signal nor HD serial input signal is supplied, the internal
sync signal serves as the reference.
INPUT 1: The HD serial input signal serves as the reference.
If this signal is not available, the unit's internal reference is used.
HD REF 2: The HD REF input signal serves as the reference.
If this signal is not available, the unit's internal reference is used.
SD REF 3: The SD REF input signal serves as the reference.
If this signal is not available, the unit's internal reference is used.
<Note>
When "1394" is selected as the menu item No.600 [VIDEO IN SEL] setting, the
output picture in the E-E mode or output picture during recording may be disturbed
in the vertical direction even when this item is set. However, there will be no
problem with the pictures which are recorded on the tape.
Description of settings
35