Panasonic AJ-HD1200A Operating Instructions Manual page 32

Setup menus
SYSTEM
Item
Superimposed
No. No.
display
25 SYSTEM FREQ
0000
0001
0002
2
0003
2
0004
2
26 HD SYS H ADV
0000
0001
2 This appears when the AJ-YA120AG (optional accessory) has been installed.
" " indicates the factory setting.
32
Setting
Superimposed
display
For selecting the system frequency
59/60 0: The 59.94 Hz or 60 Hz system frequency is selected.
50i/25P 1: The 50 Hz or 25 PsF system frequency is selected.
At this setting, the 1080/25 PsF format signals can be recorded and played back
in the same way as with the 1080/50i format.
23/24 2: The 23.98 Hz or 24 Hz system frequency is selected.
2
25 (HD) 3: The 25 Hz system frequency is selected. However, black signals are output
2
from the SD SDI output and analog composite connectors.
25 (SD) 4: The 25 Hz system frequency is selected. However, black signals are output
2
from the HD SDI output and analog component connectors.
<Note>
Merely changing this item's setting only causes the menu item to flash, and the
setting itself is not reflected in the unit. To reflect a new setting in the unit, turn off
the power and then turn it back on.
For selecting the output whose HD output phase is to be advanced by 90H in
relation to the SD output.
0H 0: Both the HD and SD signals are output in phase with the HD and SD REF
output signals.
90H 1: The HD signals are output at a phase advanced by 90H from the SD output
signals.
When the SD REF signal is input, the REF input and SD output are in-phase,
and when the HD REF signal is input, the REF input and HD output are in-
phase.
<Notes>
O The audio signals and TC signal are output in phase with the HD output.
O With the 720p format, there is a phase difference of 120H between them.
O This item's setting is fixed to "0H" when "1394" is selected as the menu item
No.600 [VIDEO IN SEL] setting or when an SD format tape is being played
back.
Description of settings