EN G LI S H MITRE SAW DW712, DW712N Congratulations! Vibration total values (triax vector sum) determined according to EN 61029: Vibration emission value a You have chosen a D WALT tool. Years of experience, thorough m/s² product development and innovation make D WALT one of the most reliable partners for professional power tool users.
E NG L I S H The undersigned is responsible for compilation of the technical file and 12. Secure work. makes this declaration on behalf of D WALT. Where possible use clamps or a vice to hold the work. It is safer than using your hand and it frees both hands to operate the tool.
EN G LI S H • Never attempt to stop a machine in motion rapidly by jamming a • Without additional support the machine is designed to accept the tool or other means against the blade; serious accidents can occur. maximum workpiece size of: •...
• Holes (40) are provided in all four feet to facilitate bench mounting. Your D WALT DW712 Mitre Saw has been designed for professional Two different sized holes are provided to accommodate different cutting wood, wood products and plastics. It performs the sawing sizes of bolts.
Page 14
ENG LI SH Always mount your saw firmly to prevent movement. To enhance • Swing the mitre arm until the latch locates it at the 0° mitre position. the portability, the tool can be mounted to a piece of 12.5 mm or Do not tighten the lever.
• To override the bevel stops, first release the saw head and push it slightly to the left, then pull out the override knob (27) and turn DW712 it into the override position (62). The override knob automatically clicks in place.
ENG LI SH • Depress the head to allow the blade to cut through the timber and • Do not cross your hands. enter the plastic kerf plate (31). • Keep both feet firmly on the floor and maintain proper balance. •...
E NG L I S H • Set your saw to the prescribed angles and make a few trial cuts. • Flip the grooving stop (12) towards the front of the saw. • Practice fitting the cut pieces together. • Adjust the grooving depth adjustment knob (15) to set the depth of the groove cut.
EN G LI S H Protecting the Environment Separate collection. This product must not be disposed of with normal household waste. Cleaning Before use, carefully check the upper blade guard, movable lower Should you find one day that your D WALT product needs replacement, blade guard as well as the dust extraction tube to determine that it will or if it is of no further use to you, do not dispose of it with household...
Page 20
Dutch Tel: 32 70 220 063 Fax: 32 70 225 585 Luxembourg Nieuwlandlaan 7, IZ Aarschot B156 French Tel: 32 70 220 062 Fax: 32 70 222 441 België en B-3200 Aarschot www.dewalt.be Luxemburg Danmark WALT Tlf: 70201511 Sluseholmen 2-4 Fax: 70224910 2450 København SV www.dewalt.dk...