Panasonic CF-W2 Series XP Operating Instructions Manual page 60

Reinstalling Software
60
To divide the hard disk into two partitions (for OS and data)
Press the 2 key.
Enter the basic partition size (GB) for the operating system installation
and press the Enter key.
• You can cancel this operation by pressing the 0 key.
• The data partition size is the remainder after subtracting the basic
partition size. (Data partition: 1 GB or more)
Maximum settable size differs depending on the model.
To reinstall Windows in the original partition without changing the parti-
tion configuration
Press the 3 key.
• The first partition size must be 6 GB or more of the hard disk size.
Reinstallation cannot be performed with a small partition size.
<When the hard disk backup function has been enabled>
If you select [1] or [2], the message [The Backup function has been enabled.
If [Recovery] is executed, the Backup function will be disabled, and your
Backup data will be lost.] appears. In this case, press the Y key.
If the message [Computer must be rebooted in order to execute [Recovery.]]
appears, press the R key.
D At the confirmation message, press the Y key.
The operation of reinstallation for the hard disk starts automatically.
(The operations take about 20 minutes.)
Do not interrupt the reinstallation procedure before completion, for
example by turning off the computer or pressing the Ctrl + Alt + Del
key, as this may prevent Windows from starting up, or may cause data
to be lost so that the reinstallation procedure cannot be executed.
E The message "[Recovery] is complete" will be displayed. Remove the
Product Recovery DVD-ROM, and press any key to shut down the com-
puter.
4
Return the Setup Utility settings to their default values.
Return the Setup Utility to its settings at the time of shipment to ensure
proper setup of Windows.
A Turn on the computer, and press the F2 key while [Panasonic] boot
screen is displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Password, and press
the Enter key.
B Press the F9 key.
At the confirmation message, select [Yes] and press the Enter key.
C Press the F10 key.
At the confirmation message, select [Yes] and press the Enter key.
The Setup Utility will close, and the computer will restart.