Panasonic CF-W2 Series XP Operating Instructions Manual page 53

Disk Operations
Cannot eject disk
Cannot play back TV programs
recorded on a commercial DVD
recorder
Reinstalling B's Recorder/B's CLiP
When reinstalling, you will be asked
for a serial number
SD Card Setup (SD Memory Card security function)
Cannot log-on to Windows with the
SD memory card
Fast User Switching Function
Some applications may not work
properly
Wireless LAN
Wireless LAN cannot be used
Access point is not detected
Expanding Memory
You do not know the available RAM
module
Cannot tell whether the RAM module
has been correctly installed
The RAM module has not been rec-
ognized
Is the computer powered on?
Open lever works only when the computer is powered on.
To remove a disk when the computer is powered off, insert a pointed object
(e.g., the bent-out tip of a paper clip, or the tip of a pencil or ballpoint pen)
into the emergency hole, and then move it (
In the following cases, finalize the recording on the DVD recorder:
• If the program was recorded in DVD-R/RW in video mode
• If the program was recorded in DVD-RW in VR mode
Input the following serial number.
B's Recorder:
B's CLiP:
Windows log-on user name and password are not set in the SD memory
card correctly.
Enter the Windows user name and password without using the SD memory
card.
After logging on to Windows, set the same user name and the password on
the SD memory card and Windows, using one of the following operations:
• Change the setting for the SD memory card [SD Card Setup]
• Change the setting for Windows [Control Panel] (
Measures" in onscreen Reference Manual)
When switching to a different user with the Fast User Switching function,
the following problems may occur:
• Some applications may not work properly.
• Key combination with the Fn key may not work.
• It may not be possible to set the settings of the display.
• The wireless LAN cannot be used.
• The B's CLiP icon will no longer be shown on the notification area and
CD-RW disk cannot be written.
In this case, log-off all users without using Fast User Switching function,
and try the operation once more. If the problem persists, restart the com-
puter.
When the wireless LAN function is turned off, turn it on using Intel
PROSet/Wireless Software. (
Check that the access point is powered on.
For detailed information, refer to "Chapter 7: Problems with Wireless LAN"
in onscreen Reference Manual.
page 72
You can check whether the RAM module is recognized using the [Informa-
tion] menu in the Setup Utility. (
If the RAM module is not recognized, turn the computer off and reinsert.
Make sure the RAM module has been properly inserted.
Use the RAM module that supports the recommended specifications
( page 29).
page 44).
"Chapter 2: Security
page 40)
page 33)
®
53