To Enter And Duplicate Wireless Keys - ADT Safewatch Pro 3000 Installaton Manual

Safewatch Pro 3000 Installation Instructions

To Enter and Duplicate Wireless Keys

This procedure programs the wireless keys, but a key is not active until it is assigned to a user number (see System
Operation section, assigning attributes command).
If the D key was previously pressed (from *58 Menu mode) to enter and duplicate 5804 and/or 5804BD wireless
keys, the following screens appear.
PROMPT
TEMPLATE ?
1–6 1
L 01 02 03 04
T 23 22 21 23
PARTITION
1
ENTER START ZONE
00 = QUIT 36
INPUT S/N L
AXXX-XXXX –
XMIT TO CONFIRM
PRESS TO SKIP
5-6
VALID ENTRIES
Template Number
1–3 = 5804 templates
4–6 = 5804BD templates
[ ∗ ] to continue
Template Display
[ ∗ ] to continue
Partition
1 = partition 1
2 = parition 2
3 = common partition
[ ∗ ] to continue
Start Zone Number
[ ∗ ] to continue
Serial Number
[ ∗ ] to continue
Confirm
[ ∗ ] to continue
EXPLANATION
1. Enter Template number 1–6 (from next page).
See the defaults provided for each template in the chart that
follows these procedures.
2. Select from templates. Press [ ] to display template (1 shown
selected). NOTE: If necessary, press [#] to back up and re-enter
template number.
3. Press [#] if you want to return to zone attributes screen.
4. When [ ] is pressed, the selected template will be displayed.
Top line of display represents loop numbers, bottom line
represents zone type assigned for each zone.
5. Press [ ] to accept template.
6. Enter the partition in which the key is to be active.
7. Press [∗] to continue.
8. The system will search for the highest available consecutive 4-
zone group (the four zones in the case of the 5804 and 5804BD),
and display the lowest zone number of the group.
If you want to start at a different zone, enter the zone desired,
and press [ ]. If that zone number is displayed, the system has
the required number of consecutive zones available, beginning
with the zone you entered. If not, the system will again display a
suggested zone that can be used.
If the required number of consecutive zones is not available at all,
the system will display "00".
9. Press [ ] to accept.
10. Manually enter the serial number printed on the label for the
wireless key or press and release the button to transmit its serial
number.
11. Press [ ] to accept the serial number. The system will check for
duplicate.
12. If necessary, press the [#] key to back up without saving, and re-
enter the serial number.
Use the [A] key to move forward within the screen, and the [B] key to
move backward.
13. If "Yes" was entered at the SET TO CONFIRM? prompt
previously (see first prompt following entry into the 58 Expert
Programming Mode), the display on the left will appear. Confirm
serial and loop numbers by activating the wireless key.
IMPORTANT:
When confirmed, the key is not active until it is assigned to a user
number (using the assigning attributes command, attribute "4"). See
System Operation
section for procedure.