Xerox Phaser 6125 User Manual page 77

Network Setup
Specifies printer settings affecting jobs sent to the printer through a network port.
■
■
Item
Ethernet
TCP/IP
Get IP Address
IP Address,
Network Mask,
Gateway
Address
Protocol
Downloaded From ManualsPrinter.com Manuals
The settings in the Network Setup menu cannot be set when entering this menu during
printing.
You need to restart the printer to activate the new settings. After making the settings, turn
off the printer and then turn it on again.
Description
Specifies the communication speed and the modes of Ethernet.
Auto (default)
■
Automatically changes between 10M Half Duplex, 10M Full Duplex, 100M
Half Duplex, and 100M Full Duplex.
10M Half Duplex
■
10M Full Duplex
■
100M Half Duplex
■
100M Full Duplex
■
Specifies the settings to use the TCP/IP protocol.
Specifies whether to automatically or manually retrieve the IP address.
DHCP/Autonet (default)
■
Automatically sets the IP address.
BOOTP
■
Uses BOOTP to set the IP address automatically.
RARP
■
Uses RARP to set the IP address automatically.
DHCP
■
Uses DHCP to set the IP address automatically.
Panel
■
You can set the IP address manually by entering it on the operator panel.
These items are used to check the addresses that have been obtained
automatically or to specify addresses manually. Enter the address in the format
of xxx.xxx.xxx.xxx. You can specifies values in the range of 0 to 255 for xxx.
To set addresses manually, set the Get IP Address to Panel.
■
IP addresses are managed in the entire network. An incorrect IP address
■
may affect the whole network. For the addresses you need to set manually,
contact your network administrator.
Set Enable when using the protocol. When Disable is selected, the protocol
cannot be activated.
LPR (default: Enable)
■
Port 9100 (default: Enable)
■
FTP (default: Enable)
■
SNMP (default: Enable)
■
Email Alerts (default: Enable)
■
CentreWare IS (default: Enable)
■
Phaser® 6125 Color Laser Printer
Description of Menu Items
5-7