Xerox Phaser 6125 User Manual page 112

Commands That Can Be Used in E-mail Text
Use each command according to the following rules.
■
■
■
When the same command is written two or more times in one e-mail, the second and
subsequent commands are ignored.
Command
#Password
#NetworkInfo
#Status
#SetMsgAddr
Example of Commands
1.
2.
3.
Downloaded From ManualsPrinter.com Manuals
Prefix all commands with "#", and specify the #Password command at the top of the
e-mail.
Command lines without "#" are ignored.
Write one command on each line and separate each command and parameter with a space
or a tab.
Parameter
Password
Recipient E-mail
address
When the read only password is "ronly", and to check the printer status:
#Password ronly
#Status
When the full access password is "admin", and to set the recipient e-mail address to
"service@xerox.com":
#Password admin
#SetMsgAddr service@xerox.com
When the full access password is "admin", and to set the recipient e-mail address to
"service@xerox.com", then confirm the setting result on the network settings list:
#Password admin
#SetMsgAddr service@xerox.com
#NetworkInfo
Note:
Describe the "#SetMsgAddr" command before the "#NetworkInfo" command. If
they are written in reverse, the information retrieved by the "#NetworkInfo" command and
the result of executing the "#SetMsgAddr" command may differ.
Phaser® 6125 Color Laser Printer
Description
Use this command at the top of the e-mail when a password
for read only or full access is set. You can omit this command
when the password is not set.
Set this when you want to check information on the network
settings list.
Set this when you want to check the printer status.
Use this command to specify the e-mail address to which
e-mail reports are sent to. This command can only be used
when the full access password is specified by the #Password
command.
8-8
Managing the Printer