Product Specifications - Ryobi ABE04G Operator's Manual

WARNING:
The operation of any power tool can result in foreign objects being thrown into your eyes, which can result
in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety
glasses with side shields and, when needed, a full face shield. We recommend Wide Vision Safety Mask
for use over eyeglasses or standard safety glasses with side shields. Always use eye protection which
is marked to comply with standards.
KNOW YOUR bLOWER ATTAchMENT
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
UNPAcKING
This product requires assembly.
 Carefully remove the items from the box. Make sure that
all items listed in the packing list are included.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, contact Ryobi cus-
tomer service.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
SYMbOLS
SAVE ThESE INSTRUcTIONS
FEATURES
ASSEMbLY

PROdUcT SPEcIFIcATIONS

Weight ................................................................... 1.82 lbs.
Air Velocity:
Km/h ...........................................................................241.4
CFM ................................................................................7.9
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
JOINING ThE bLOWER ATTAchMENT TO ThE
ATTAchMENT ShAFT
See Figure 2.
Use the attachment securing cap for the one-time assembly
of the blower attachment to the attachment shaft.
 Install the attachment securing cap over the end of the
attachment shaft as shown.
 Align the raised tabs inside the opening on the blower
housing with the positioning holes on the attachment shaft.
Insert the end of the attachment shaft into the opening on
the blower housing and rotate slightly until the tabs lock
into the positioning holes.
 Rotate the attachment securing cap clockwise until the
shaft is completely secure.
NOTE: When fully secure, the cap cannot be rotated
counterclockwise.
3