T T R R A A N N S S M M I I T T T T E E R R / / R R E E C C E E I I V V E E R R L L E E A A R R N N R R O O U U T T I I N N E - Avital 2101L Installation Manual

I I m m p p o o r r t t a a n n t t : Never use this wire to drive anything but a
relay or a low-current input. The transistorized output
can only provide 200mA of current. Connecting
directly to a solenoid motor cause failure. .
H H 1 1 / / 1 1 5 5 Y Y E E L L L L O O W W ( ( + + ) ) S S w w i i t t c c h h e e d d I I g g n n i i t t i i o o n n I I n n p p u u t t
Connect this wire to an ignition source. This input must
show (+)12V with the key in run position and during
cranking. Make sure that this wire cannot be shorted to
the chassis at any point.
© 2009 Directed Electronics, inc.
TO IGNTION SYSTEM TO IGNTION SYSTEM
H1/9 YELLOW
PRIMARY HARNESS
9