Avital 2101L Installation Manual page 7

H H 1 1 / / 8 8 B B L L U U E E / / B B L L A A C C K K U U n n l l o o c c k k # # 3 3 0 0 C C o o m m m m o o n n ( ( O O u u t t p p u u t t ) )
See H1/5.
H H 1 1 / / 9 9 V V I I O O L L E E T T U U n n l l o o c c k k # # 8 8 7 7 N N o o r r m m a a l l l l y y O O p p e e n n ( ( I I n n p p u u t t ) )
See H1/5.
H H 1 1 / / 1 1 0 0 W W H H I I T T E E ( ( + + / / - - ) ) P P a a r r k k i i n n g g L L i i g g h h t t F F l l a a s s h h O O u u t t p p u u t t : : This wire
provides a high current + or - output to light flash the
parking lights (+ is factory default setting). If the vehicle
has a negative parking light circuit, the light flash
jumper on the control module must be moved.
H H 1 1 / / 1 1 1 1 B B L L A A C C K K ( ( - - ) ) C C h h a a s s s s i i s s G G r r o o u u n n d d I I n n p p u u t t : This wire to a
clean, paint-free sheet metal location (driver kick panel)
using a factory bolt that DOES NOT have any vehicle
component grounds attached to it. A screw should only
be used in conjunction with a two-sided star washer.
Under dash brackets and door sheet metal are not
acceptable ground points. It is recommended that all
components be grounded at the same location.
7
© 2009 Directed Electronics, inc.